Feature for vertical L shape shrink sealer and tunnel:

1.L-shaped structure sealing knife is driven vertically up and down by cylinder to ensure that the sealing line is in the center of the product, reducing sealing folds, suitable for products with large height and high requirements for shrinkage effect
2.Adopt high temperature resistant alloy one-piece sealing knife with Dupont Teflon coating on the surface, anti-stick and easy to clean, firm sealing
3.Adjustable product size, no need to change molds and bag makers, electric adjustment of sealer opening height
4.using the lower side of the air transport technology, equipped with high temperature visual observation window, real-time control of the contraction process
5.Conveyor, wind motor frequency conversion speed control, adjustable air outlet ratio, adjustable air angle
6.the upper shell can be lifted design, easy to clean and maintenance

How to use vertical l shape shrink wrap machine?

L-type sealing and cutting machine is a device supporting the shrink machine, it is relatively simple to use, the following methods of use of the l bar shrink wrap machine.
1. Place the machine on a level ground, before starting the machine, check whether the machine parts are loosened, shifted and other undesirable phenomena during the transportation process, if found, they should be adjusted. The shrink wrap machine has been debugged before leaving the factory, in order to make the machine work in the best condition, give full play to the effectiveness of the machine, service life, the machine must be operated and maintained by a person responsible for the operator must be familiar with this manual before operating, so as not to damage the machine.
2、For your personal safety, please ground the machine before use, and ensure that it is in good contact.
3、Turn on the power, and turn on the power switch, according to the thickness of the shrink film material, adjust the appropriate sealing and cutting time (generally should be controlled in about 2 seconds), sealing and cutting time to cut off the film and the best sealing effect is appropriate, too long time is easy to damage the heating wire knife slot and high temperature paint cloth, too short will affect the sealing effect or cut constantly.
4, according to the size of the package and packaging needs, adjust the appropriate transport time.
5、The operator will put the film sleeve shaft through the center of the film cylinder, move the roller positioning block to the film cylinder ends and fasten it to the film sleeve shaft. Place the sleeve shaft on the roller seat (when placing, pay attention to the film open side facing the operator), after passing the film through the perforator on the roller seat, separate the film and pass the film opener, so that one layer of film is under the sliding table and one layer is on top of the sliding table, and seal and cut the vertical side, refer to the diagram of film threading for operation